All Discussions Tagged 'Switching' - AccuRender nXt2024-03-28T16:24:56Zhttp://accurender.ning.com/forum/topic/listForTag?tag=Switching&feed=yes&xn_auth=noAutocad 2013, decals, and automatic view switchingtag:accurender.ning.com,2013-03-22:6293855:Topic:839172013-03-22T03:41:33.616ZRon Eddyhttp://accurender.ning.com/profile/RonEddy
<p>Does anyone know what setting to change in Autocad 2013 to prevent the following?</p>
<p>Attaching a decal, I generally work in one of the isometric views because you can see all 3 points needed to place the decal: Lower Left Corner, Upper Left Corner, Lower Right Corner - right?</p>
<p>After I select the Lower Right Corner, AutoCAD switches to the face-on view corresponding to the orientation of the decal (for example front view if it was applied to the front face of the solid), then after…</p>
<p>Does anyone know what setting to change in Autocad 2013 to prevent the following?</p>
<p>Attaching a decal, I generally work in one of the isometric views because you can see all 3 points needed to place the decal: Lower Left Corner, Upper Left Corner, Lower Right Corner - right?</p>
<p>After I select the Lower Right Corner, AutoCAD switches to the face-on view corresponding to the orientation of the decal (for example front view if it was applied to the front face of the solid), then after I "accept" the placement of the decal, AutoCAD switches to Top View.</p>
<p>Nothing like this happened in AutoCAD 2010. I'm guessing this isn't caused by Accurender because it also happens intermittently when modeling.</p>
<p>Anyway, any insight would be most appreciated. I apply a lot of decals.</p>
<p>Thanks,</p>
<p>Ron Eddy</p>