3D Face rendering in black only?? - AccuRender nXt2024-03-28T09:13:51Zhttp://accurender.ning.com/forum/topics/3d-face-rendering-in-black-only?commentId=6293855%3AComment%3A126902&x=1&feed=yes&xn_auth=noHey Peter, I remember you fro…tag:accurender.ning.com,2017-06-30:6293855:Comment:1269022017-06-30T22:40:05.904ZTony Joneshttp://accurender.ning.com/profile/TonyJones
<p>Hey Peter, I remember you from Sven, we used your products and renders many times, in fact you put me onto this product back when it was AR3 Accurender. :)</p>
<p>No I have looked at the blocks and exploded them, they are made up of 3D faces, it looks like they were possibly 3Ds blocks once. however I managed to figure it out, there is a section in AEC 2017 Properties I didn't know about, it had the material selection which was not set to By Layer. lesson learned.</p>
<p></p>
<p>Thanks…</p>
<p>Hey Peter, I remember you from Sven, we used your products and renders many times, in fact you put me onto this product back when it was AR3 Accurender. :)</p>
<p>No I have looked at the blocks and exploded them, they are made up of 3D faces, it looks like they were possibly 3Ds blocks once. however I managed to figure it out, there is a section in AEC 2017 Properties I didn't know about, it had the material selection which was not set to By Layer. lesson learned.</p>
<p></p>
<p>Thanks again!</p> If the cutlery is part of a C…tag:accurender.ning.com,2017-06-19:6293855:Comment:1266342017-06-19T11:50:20.996ZPeter Milnerhttp://accurender.ning.com/profile/PeterMilner
<p>If the cutlery is part of a CAD block, I would go into the block and check the material assignment there.</p>
<p>You may even find that the cutlery is a block within a block in which case you may need to explode it to assign the material properly.</p>
<p>Maybe you could post a link to the block so that we can check it out.</p>
<p>If the cutlery is part of a CAD block, I would go into the block and check the material assignment there.</p>
<p>You may even find that the cutlery is a block within a block in which case you may need to explode it to assign the material properly.</p>
<p>Maybe you could post a link to the block so that we can check it out.</p> My guess is to check the refr…tag:accurender.ning.com,2017-06-16:6293855:Comment:1267312017-06-16T03:20:44.902ZGeorge Ioannidishttp://accurender.ning.com/profile/GeorgeIoannidis
<p>My guess is to check the refraction and reflection ray recursion number settings.</p>
<p>My guess is to check the refraction and reflection ray recursion number settings.</p>