AccuRender nXt

advanced rendering for AutoCAD

Autocad 2013, decals, and automatic view switching

Does anyone know what setting to change in Autocad 2013 to prevent the following?

Attaching a decal, I generally work in one of the isometric views because you can see all 3 points needed to place the decal: Lower Left Corner, Upper Left Corner, Lower Right Corner - right?

After I select the Lower Right Corner, AutoCAD switches to the face-on view corresponding to the orientation of the decal (for example front view if it was applied to the front face of the solid), then after I "accept" the placement of the decal, AutoCAD switches to Top View.

Nothing like this happened in AutoCAD 2010.  I'm guessing this isn't caused by Accurender because it also happens intermittently when modeling.

Anyway, any insight would be most appreciated.  I apply a lot of decals.

Thanks,

Ron Eddy

Views: 383

Reply to This

Replies to This Discussion

Probably you are clicking on the view cube or wheel without knowing an thus changing to the view/ face you click on.

It sounds like you have dynamic UCS turned on.

It's a hateful thing. Turn it off.

Set UCSFOLLOW to 0.

UCSFOLLOW it was!  A system variable carried in the drawing.

Thank You SO much!  It was driving me insane!

You're welcome! That variable is just as annoying as the dynamic UCS.

RSS

Search

Translate

Latest Activity

Paul Cloutier posted a discussion

nXtRender vs AutoCAD RT

My first try with nXt.Same models, same textures, same lights (ies 100W x 4).2 minutes render time.See More
Dec 25, 2019
Paul Cloutier replied to Paul Cloutier's discussion Material help !
"Hello Kevin Thanks. I will look at Yoooootube for more infos."
Dec 25, 2019
Kevin Lockwood replied to Paul Cloutier's discussion Material help !
"I used your mask (alpha) file as a mask in photoshop and saved out to png."
Dec 24, 2019
Paul Cloutier replied to Paul Cloutier's discussion Material help !
"Hello Kevin It's work with your .PNG file. Did you just SAVEAS a .JPG to a .PNG with a image editor ? Capture.PNG Render.png"
Dec 24, 2019
mike makki replied to Daniel Hargreaves's discussion Accustudio
"I can help daniel"
Dec 24, 2019
Kevin Lockwood replied to Paul Cloutier's discussion Material help !
"I'm not sure if you are applying the tree to the region as a decal or as part of a material. if a decal onto the region, I don't think AR will allow 2 decals. I guess you could stack them but I don't think one applies to the other…"
Dec 23, 2019
Paul Cloutier posted a discussion

Material help !

Hello...Need help for settings alpha for this tree bitmap.AutoCAD 2018.Thanks !See More
Dec 23, 2019
Daniel Hargreaves posted a discussion

Accustudio

I know this is hard to believe, but Accustudio is over 20 years old. It has been quiet for a couple of years now at the site. I'm looking to hand it off to the next generation. Is there anyone interested in working on the site and eventually taking over the ownership of it?See More
Dec 3, 2019

© 2020   Header image courtesy Peter Milner   Powered by

Badges  |  Report an Issue  |  Terms of Service