AccuRender nXt

advanced rendering for AutoCAD

Does anybody have the same issue; if i try to render a filleted solid i get black lines on the edges close to the camera if a displacement map is used.

Any help would be greatly appreciated.

Views: 97

Reply to This

Replies to This Discussion

Those aren't black lines but holes in the model, due to applied displacement map (number of 3D faces are "lifted" along the normal so there is a gap between the faces on the edge). Try to lower the displacement distance. Instead of fillet try to use chamfer of the edges.

This one is with  only 1mm displacement;the following as meshed solid/meshoption command applied;it seems to be that meshing/increasing the polygon count solves the problem.

Greetings to Greece!

Nice! Greetings to Deutschland too Thorsten, tschüss!

RSS

Search

Translate

Latest Activity

Roy Hirshkowitz replied to Peter Milner's discussion Advanced textures
"I'm assuming you're asking for nXtRender.  It's been a long time since I've looked at this stuff-- here's what I can remember: Displacement mapping changes the underlying geometry using a texture.  It's an…"
May 10
Peter Milner posted a discussion

Advanced textures

A couple of questions about advanced textures:What do the settings under displacement mapping do - how do they affect the texture?When using a specular map, should the base material have any reflectivity or is it all controlled by the map?See More
May 10
Roy Hirshkowitz replied to Marko Stout's discussion renderfarm
"We've been phasing out most 32 bit products.  There isn't a lot of demand for them and they're becoming increasingly difficult to support.  I should probably remove the link."
May 4
Marko Stout posted a discussion

renderfarm

Why does renderfarm 32 bits not exist?See More
May 4
Roy Hirshkowitz replied to akinlolu olugboji's discussion No Open and Saveas Dialogue Boxes in AutoCad 2015
"Nope."
Apr 30
akinlolu olugboji replied to akinlolu olugboji's discussion No Open and Saveas Dialogue Boxes in AutoCad 2015
"Thanks. Do you have an idea what causes the change as I did nothing alone that line to warrant such?"
Apr 30
Roy Hirshkowitz replied to akinlolu olugboji's discussion No Open and Saveas Dialogue Boxes in AutoCad 2015
Apr 22
akinlolu olugboji posted a discussion
Apr 20

© 2019   Header image courtesy Peter Milner   Powered by

Badges  |  Report an Issue  |  Terms of Service