AccuRender nXt

advanced rendering for AutoCAD

I use the scroll wheel on my mouse alot in autocad to zoom in and out and atmies to scroll up and down a list in standard windows programs.

Problem is after some time the scrolling become eratic. What could be the cause and also solution to the problem.

Views: 132

Reply to This

Replies to This Discussion

Hello Akinlolu,

The reason is probably dust which has accumulated below the scroll wheel over time.

You can unscrew the mouse remove the wheel and clean it with alcohol or something similar.

Of course getting a new mouse is another option. :P

Will give the cleaning a shot. It being long since I did this typs of cleaning in the days of track ball mouse, the ball was always clean, it the rollers that picks up the dirt from the ball.

A new mouse soon goes to this state of eraticness after a few weeks.

thanks for the tip

Have you installed the proper mouse software (from its manufacturer) or it just uses some generic Windows drivers? Maybe you could start from there, before you disassemble the mouse ;)

It is a generic windows driver. No installation software came with the mouse.
Gotten another one for now so should I pull this apart and cannot put it back together again, I would not be mouseless

RSS

Search

Translate

Latest Activity

Roy Hirshkowitz replied to Peter Milner's discussion Advanced textures
"I'm assuming you're asking for nXtRender.  It's been a long time since I've looked at this stuff-- here's what I can remember: Displacement mapping changes the underlying geometry using a texture.  It's an…"
May 10
Peter Milner posted a discussion

Advanced textures

A couple of questions about advanced textures:What do the settings under displacement mapping do - how do they affect the texture?When using a specular map, should the base material have any reflectivity or is it all controlled by the map?See More
May 10
Roy Hirshkowitz replied to Marko Stout's discussion renderfarm
"We've been phasing out most 32 bit products.  There isn't a lot of demand for them and they're becoming increasingly difficult to support.  I should probably remove the link."
May 4
Marko Stout posted a discussion

renderfarm

Why does renderfarm 32 bits not exist?See More
May 4
Roy Hirshkowitz replied to akinlolu olugboji's discussion No Open and Saveas Dialogue Boxes in AutoCad 2015
"Nope."
Apr 30
akinlolu olugboji replied to akinlolu olugboji's discussion No Open and Saveas Dialogue Boxes in AutoCad 2015
"Thanks. Do you have an idea what causes the change as I did nothing alone that line to warrant such?"
Apr 30
Roy Hirshkowitz replied to akinlolu olugboji's discussion No Open and Saveas Dialogue Boxes in AutoCad 2015
Apr 22
akinlolu olugboji posted a discussion
Apr 20

© 2019   Header image courtesy Peter Milner   Powered by

Badges  |  Report an Issue  |  Terms of Service