AccuRender nXt

advanced rendering for AutoCAD

I use the scroll wheel on my mouse alot in autocad to zoom in and out and atmies to scroll up and down a list in standard windows programs.

Problem is after some time the scrolling become eratic. What could be the cause and also solution to the problem.

Views: 59

Reply to This

Replies to This Discussion

Hello Akinlolu,

The reason is probably dust which has accumulated below the scroll wheel over time.

You can unscrew the mouse remove the wheel and clean it with alcohol or something similar.

Of course getting a new mouse is another option. :P

Will give the cleaning a shot. It being long since I did this typs of cleaning in the days of track ball mouse, the ball was always clean, it the rollers that picks up the dirt from the ball.

A new mouse soon goes to this state of eraticness after a few weeks.

thanks for the tip

Have you installed the proper mouse software (from its manufacturer) or it just uses some generic Windows drivers? Maybe you could start from there, before you disassemble the mouse ;)

It is a generic windows driver. No installation software came with the mouse.
Gotten another one for now so should I pull this apart and cannot put it back together again, I would not be mouseless

RSS

Search

Translate

Latest Activity

mike makki commented on Ljiljana Jankovic's photo
Thumbnail

kuhinja

"nice render for Nxt.."
Jul 17
Valeria replied to Valeria's discussion Combining daylighting and artificial lighting for an exterior rendering
"thank you so much!!"
Jul 16
Roy Hirshkowitz replied to Valeria's discussion Combining daylighting and artificial lighting for an exterior rendering
"Post an example image of what you're getting.  It will be easier to evaluate."
Jul 16
Ljiljana Jankovic commented on Ljiljana Jankovic's photo
Thumbnail

kuhinja

"Thank you!"
Jul 15
Ljiljana Jankovic commented on Ljiljana Jankovic's photo
Jul 15
Ljiljana Jankovic commented on Ljiljana Jankovic's photo
Jul 15
Rich Hart replied to Sampdoria's discussion License Problem
"No, the old build only work with AutoCAD versions through 2013."
Jul 14
mike makki replied to Sampdoria's discussion License Problem
"hi rich does the old build version works with 2017 autocad? thanks"
Jul 13

© 2018   Header image courtesy Peter Milner   Powered by

Badges  |  Report an Issue  |  Terms of Service