AccuRender nXt

advanced rendering for AutoCAD

AutoCAD 2013.

When running a test rendering at 1500x1000 pixels in Walkabout, the exterior, sunlit, single-channel rendering looks great with the following settings:

Brightness: 0.0

Burn: 0.0

Saturation: 0.0

Indirect: OFF

Ambient: Medium (1.00)

When I change ONLY the resolution to 10,800x7200 for the final rendering in Walkabout, the image is almost completely washed out, even after several passes. The Brightness slider needs to be set to -.50 to get the image back to a close match with the original.

Going back to the lower resolution requires setting the Brightness back to 0.0.

Odd...

-Bill

Views: 116

Reply to This

Replies to This Discussion

Which engine?

standard

RSS

Search

Translate

Latest Activity

Roy Hirshkowitz replied to Roy Hirshkowitz's discussion AccuRender Studio
"Thanks, I'll check on the first two.  The third is normal behavior-- data conversion stops when the arstudio data is detected.  There is a command to remove the arstudio data which would allow you to start from scratch-- probably not…"
Apr 19
Peter Milner replied to Roy Hirshkowitz's discussion AccuRender Studio
"Two things don't seem to translate from nXt: Procedural bump and orientation of texture in a material.   Also, if a decal is changed using nXt, Studio continues to display the original decal. Editing the decal in the Studio material pallet…"
Apr 19
Peter Milner replied to Roy Hirshkowitz's discussion AccuRender Studio
"That sorted it - using the Studio camera and then selecting "Get AutoCAD view"."
Apr 19
Roy Hirshkowitz replied to Roy Hirshkowitz's discussion AccuRender Studio
"Interesting.  ArStudio has its own WalkAbout-like feture, it's the little camera button.  If you do it while the preview is running you should see the view changes automatically in the rendering."
Apr 19
Peter Milner replied to Roy Hirshkowitz's discussion AccuRender Studio
"I'm having trouble getting the desired view in Studio. I've tried setting the view in nXt walkabout and then using that to set the AutoCAD view. However, when I render from Studio, it gives me something different (see images below)."
Apr 19
Roy Hirshkowitz replied to Peter Milner's discussion Multiple cores
"There should be an Update Manager in the Start menu.  Grab and install 0267.  If this doesn't work I'll send a link."
Apr 16
Peter Milner replied to Peter Milner's discussion Multiple cores
"Okay. Just tried to install and run ArStudio, but I get this message inside AutoCAD:"
Apr 16
Roy Hirshkowitz replied to Peter Milner's discussion Multiple cores
"Sort of-- nXt has a hard-coded max of 32 but you get diminishing returns before than point.  If you go beyond 32 they can sometimes be used, depending on the load.  I guess I would still think of 32 as a practical limit. ArStudio should…"
Apr 12

© 2021   Header image courtesy Peter Milner   Powered by

Badges  |  Report an Issue  |  Terms of Service