Normally, nXtRender registers its commands with AutoCAD during installation. On occasion, this mechanism may fail. In this case you will need to manually load nXt the first time you run it in a particular version of AutoCAD.
Use the following procedure:
Type _appload at the command line.
Navigate to the folder where nXt was installed. This is normally C:\Program Files\AccuRender nXt
Select one of the following files depending on your platform:
For example, you should be able to load the one named AccuRender nXt_22_64.arx for AutoCAD 2018 or AutoCAD Architecture 2018, on a 64 bit computer.
Check the AutoCAD command line to verify that the application loaded without error. At this point you should be able to type nxt or ar5 to launch the application. You should not have to repeat this procedure again for this version of AutoCAD. Simply typing nxt or ar5 at the command prompt should cause nxt to load. You may need to repeat this procedure if you install another version of AutoCAD.
Starting a new thread...Latest version of AccuRender Studio is here. Among other changes:ArStudio command automatically loads the model and begins interactive rendering in addition to bringing up the Control Panel palette.Decal interface has been redone to include multiple decals and cylindrical projections.Legacy data is being handled a little better.See More
"Here's how you adjust the overall transparency--
Edit the Decal material in the Material Editor.
Go to Opacity and change it to 0 using the slider (I may do this automatically at some point).
Edit the Opacity Map (not the Color Map) by…"
"Strength is supposed to do that-- I'll verify. I'm working on a few things right now-- should have a build for you by tomorrow or so.
Some legacy items are not persistent, including materials (you should only need to have the…"
"Sorry-- I was out of town for a few days.
You should be able to replace the decal using the ArDecal command and it will handle everything automatically-- just use the png provided.
If you want to use the material editor you'll need to…"