advanced rendering for AutoCAD
I am currently working on a rendering that clearly has a units issue. I remember there are two unit commands, however I can only remember DDUNITS/UNITS. Whats the other command?
Right now my grass is knee high & my bricks are as tall as a person; so somewhere the units are set to mm, but I can't find it.
Type, 'insunits' at the command prompt, if you are working in mm then it should be set to 4.Hope this helps.
Thank you very much! That was the command that I needed.
You are welcome!
© 2023 Header image courtesy Peter Milner Powered by