AccuRender nXt

advanced rendering for AutoCAD

2-n-Blue

Half Bathroom

Comment

You need to be a member of AccuRender nXt to add comments!

Join AccuRender nXt

Comment by Rey F. Rosario Berrios on April 10, 2012 at 4:00pm

Thanks Marc!

Comment by Marc Chaumier on April 10, 2012 at 9:08am

Nice room!

Search

Translate

Latest Activity

norton torres posted a photo
7 minutes ago
Eric Clewes posted a photo
7 minutes ago
akinlolu olugboji replied to Albert D Hart's discussion New nXtRender 0343-NI04
"No addons installed. In the 64 bits versions, after the needed appload, the Layer Material Schemes work once you click the bottons but in an attempt the save the present scheme it freezes, both in AutoCad 2014 and 2015."
18 hours ago
alan replied to alan's discussion Distortions in nXt renderd AutCAD Architecture Curved Walls
"Yes, Roy, the units were correctly set but the model was very far from the origin (forgot about that issue).  Looks fine now.  Thanks very much for your prompt reply."
23 hours ago
Roy Hirshkowitz replied to alan's discussion Distortions in nXt renderd AutCAD Architecture Curved Walls
"This is typically a units problem or a coordinate system problem.  Check the units by typing _DDUNITS at the command line and looking at the insertion units.  If they're correct, make sure the model is not located too far from the…"
yesterday
Garret Diduck replied to Albert D Hart's discussion New nXtRender 0343-NI04
"I'm using Win7 64bit and ACA2014."
yesterday
alan posted a discussion

Distortions in nXt renderd AutCAD Architecture Curved Walls

Please see the attached images.  In AutoCAD Architecture's native renderer, and in its 3d display, the curved walls appear smooth.  In nXt the materials are uneven (with sometimes extra lines that protrude from the walls).  Distortions also appear in straight walls which should be flat and smooth though the problem is less pronounced.  I tried changing the material definitions but the problem persists.  Could this be some sort of scale definition issue?The problem persists with all the…See More
yesterday
Rich Hart replied to Albert D Hart's discussion New nXtRender 0343-NI04
"I cannot duplicate this here either. Do you happen have the "Add-ons for nXtRender" package installed on your machine? That would cause all kinds of problems, since it included older versions of the nXt modules. Look…"
yesterday

© 2014   Header image courtesy Peter Milner   Powered by

Badges  |  Report an Issue  |  Terms of Service