Error every time I click render...

[Miguel Tano Adanes]

Hy Roy, I have an error message every time I click render when a previous render has been running for a while, no matter if it is in the same file or a new one (but ACAD session alway the same). See image attached. I'm using last nXt (317) on win7 64bit. Thanks.

[Roy Hirshkowitz]

This isn't happening generally.

I'll need more information if I'm going to pursue this-- start with-- what are the exact steps needed to reproduce the problem.? Until I get it reproduced here there's little hope of solving it.  If it's only happening with specific drawings I'll need those.

[Miguel Tano Adanes]

It is happening independently by the drawing. I think I'm rendering with e4, but I'll check this. The sure is that it occurs after rendering a second time when first render has run a little bit. In fact, it often happens after I choose "no" if I want to save the previous render. I'll do some more tries. Thanks Roy.

Roy Hirshkowitz said:

This isn't happening generally.

I'll need more information if I'm going to pursue this-- start with-- what are the exact steps needed to reproduce the problem.? Until I get it reproduced here there's little hope of solving it.  If it's only happening with specific drawings I'll need those.

[Miguel Tano Adanes]

Hi Roy! This error still occurs. It happens when I stop a render with e4, open another drawing and render again with e4. Both on Acad2012 and 2013.

[Roy Hirshkowitz]

Not happening here.  If you want me to explore this one further you'll need to provide a very specific test case.  Include all drawings necessary and very specific steps for how to reproduce.  For example:

1. Open dwg A.
2. Render A.
3. Stop Rendering.
4. Open dwg B.
5. Render B

[Miguel Tano Adanes]

Right Roy, let me see if I have time tomorrow to make this test. 

Roy Hirshkowitz said:

Not happening here.  If you want me to explore this one further you'll need to provide a very specific test case.  Include all drawings necessary and very specific steps for how to reproduce.  For example:

1. Open dwg A.
2. Render A.
3. Stop Rendering.
4. Open dwg B.
5. Render B