Render Farm latest build

[Peter Milner]

Does the latest build of the Render Farm software (344) work with nXt build 318?

[Roy Hirshkowitz]

Yes-- but I will be updating the farm software early this morning to take care of two issues-- the cylindrical decal mapping and the missing side by side files required for the farm monitor software.

[Peter Milner]

I'm also getting this on two of the render nodes when I try to launch the farmer software:

[Roy Hirshkowitz]

Hmmm... that's not good.  Try installing this one on one of the nodes.  If it still doesn't work I'll need to investigate further.  Make sure you actually run the installer on the node-- don't do anything strange like copy installed files-- that won't work for sure.

[Peter Milner]

The Farm Monitor is now available on all machines, but the Farmer fails to run on two of the render nodes.

I'm going to try and re-install build 315 on all machines to see if the problem still persists. If it does, then the problem is at my end.

[Roy Hirshkowitz]

If 315 worked before it should work again.  I'm going to try a rebuild then I'll get you a new link.

[Peter Milner]

Yes. 315 Render Farmer works when I re-install it.

[Roy Hirshkowitz]

Here's the next one to try-- for testing purposes you only need to install it on the node that isn't working.  Let me know.

http://files.na.mcneel.com/accurender/4.0/wip/nXtFarm64_0347a.exe

[Peter Milner]

No, sorry. Still doesn't work.

The Farmer launches and shuts down immediately.

[Roy Hirshkowitz]

I may have found it-- building now.  Are you in the office for a few more minutes?

[Peter Milner]

Yes. At least another 15. I can hang on a bit longer if you like.

[Roy Hirshkowitz]

Try this one:

http://files.na.mcneel.com/accurender/4.0/wip/nXtFarm64_0347b.exe

[Peter Milner]

Still no go I'm afraid.