AccuRender nXt

advanced rendering for AutoCAD

I use the scroll wheel on my mouse alot in autocad to zoom in and out and atmies to scroll up and down a list in standard windows programs.

Problem is after some time the scrolling become eratic. What could be the cause and also solution to the problem.

Views: 235

Reply to This

Replies to This Discussion

Hello Akinlolu,

The reason is probably dust which has accumulated below the scroll wheel over time.

You can unscrew the mouse remove the wheel and clean it with alcohol or something similar.

Of course getting a new mouse is another option. :P

Will give the cleaning a shot. It being long since I did this typs of cleaning in the days of track ball mouse, the ball was always clean, it the rollers that picks up the dirt from the ball.

A new mouse soon goes to this state of eraticness after a few weeks.

thanks for the tip

Have you installed the proper mouse software (from its manufacturer) or it just uses some generic Windows drivers? Maybe you could start from there, before you disassemble the mouse ;)

It is a generic windows driver. No installation software came with the mouse.
Gotten another one for now so should I pull this apart and cannot put it back together again, I would not be mouseless

RSS

Search

Translate

Latest Activity

Paul Cloutier posted a discussion

nXtRender vs AutoCAD RT

My first try with nXt.Same models, same textures, same lights (ies 100W x 4).2 minutes render time.See More
Dec 25, 2019
Paul Cloutier replied to Paul Cloutier's discussion Material help !
"Hello Kevin Thanks. I will look at Yoooootube for more infos."
Dec 25, 2019
Kevin Lockwood replied to Paul Cloutier's discussion Material help !
"I used your mask (alpha) file as a mask in photoshop and saved out to png."
Dec 24, 2019
Paul Cloutier replied to Paul Cloutier's discussion Material help !
"Hello Kevin It's work with your .PNG file. Did you just SAVEAS a .JPG to a .PNG with a image editor ? Capture.PNG Render.png"
Dec 24, 2019
mike makki replied to Daniel Hargreaves's discussion Accustudio
"I can help daniel"
Dec 24, 2019
Kevin Lockwood replied to Paul Cloutier's discussion Material help !
"I'm not sure if you are applying the tree to the region as a decal or as part of a material. if a decal onto the region, I don't think AR will allow 2 decals. I guess you could stack them but I don't think one applies to the other…"
Dec 23, 2019
Paul Cloutier posted a discussion

Material help !

Hello...Need help for settings alpha for this tree bitmap.AutoCAD 2018.Thanks !See More
Dec 23, 2019
Daniel Hargreaves posted a discussion

Accustudio

I know this is hard to believe, but Accustudio is over 20 years old. It has been quiet for a couple of years now at the site. I'm looking to hand it off to the next generation. Is there anyone interested in working on the site and eventually taking over the ownership of it?See More
Dec 3, 2019

© 2020   Header image courtesy Peter Milner   Powered by

Badges  |  Report an Issue  |  Terms of Service