advanced rendering for AutoCAD
Units Problem
I am currently working on a rendering that clearly has a units issue. I remember there are two unit commands, however I can only remember DDUNITS/UNITS. Whats the other command?
Right now my grass is knee high & my bricks are as tall as a person; so somewhere the units are set to mm, but I can't find it.
Thanks
Views: 237
Replies to This Discussion
-
Permalink Reply by akinlolu olugboji on
-
Type, 'insunits' at the command prompt, if you are working in mm then it should be set to 4.Hope this helps.
-
-
Permalink Reply by Wayne Williamson on
-
Thank you very much! That was the command that I needed.
-
-
-
You are welcome!
-
© 2026 Header image courtesy Peter Milner
Powered by
