advanced rendering for AutoCAD
Bei mir stürzt Acad 2013 64 bit immer ab, sobald ich Ar5 starte.
Ist das Problem bekannt und was ich dagegen machen??
Ich habe das neueste Service Pack 2 installiert.
Was mache ich falsch??
Tags:
Any drawing or a specific drawing? If you open a blank drawing and type "nXt" what happens?
Wenn ich ein geöffnetes Autocad 13 ohne Zeichnung habe und dann Ar5 eingebe ist alles O.K.
Sobald ich jetzt aber eine grössere Zeichnung lade (ca 100 MB) und ich jetzt nxt eingebe stürtzt Acad 2013 ab.
Bei Acad 2011 und Ar5 passiert auf dem gleichen Rechner kein Absturz und AR5 rendert sauber.
Was ist bei Acad 2013 64 Bit anders??
Can it render a smaller drawing?
When does the large drawing crash-- when you first load nXt or when you start a rendering?
How does it crash? Does it just hang, does AutoCAD just shut down and go away, or is there an error message?
Wenn ich nxt lade stürtzt Acad2013 ab.
Fehlermeldung. Ich habe zuwenig Arbeitsspeicher.
Dabei hat mein Rechner 24 GB Arbeitsspeicher.
Read my previous response carefully. Answer all of the questions I asked beginning with the first one and ending with the last. If you don't answer the questions, it's much harder for me to figure out what's happening.
Your response above translated to "when I download nxt crashes Acad2013". This doesn't make sense in English. Try expressing it a little different. Does it crash when you first type "nxt" at the command line, when you start a rendering, when you load the drawing with nXt loaded?
Ich habe ein wenig weiter getestet.
Wenn ich eine kleine Zeichnung (ca. 40 MB) öffne und danach AR5 starte klappt alles wunderbar.
Wenn ich aber eine 100 MB Zeichnung öffne und danach nxt starte, stürzt Autocad 2013 ab mit der Fehlermeldung
Zu wenig Arbeitsspeicher.
Ich habe 24 GB eingebaut.
Try an audit on the large drawing, see if it picks up any problems.
Check the large drawing did not yield any problems. Alles i.O.
Kommt AR5 eigentlich mit sehr grossen Dateien sprich 300 MB und grösser zurecht oder nicht??
Hat das schon mal einer getestet in den USA??