AccuRender nXt

advanced rendering for AutoCAD

Clicking on the Bluetooth icon in the system tray shows one of the options, "Allow  a Device to Connect" as greyed out, meaning I cannot connect any new device apart from the which was installed before this occurred.  Unfortunately I do not know how this came about or how I can undo it. It is now the situation on both my laptops.

Views: 222

Reply to This

Replies to This Discussion

Try going to Control Panel-->Hardware and Sound-->Add a device

I believe Windows will only allow you to install a device automatically that is actually plugged in. That does beg the question as to why you have the option to 'add a device' when it's Bluetooth.

This is not working either, The PC is not found neither does it see any other Bluetooth device.

Interesting. I found this on Microsoft's site. See if it helps.

I have gone this route on the Windows 7 laptop and the situation remains the same. While on Windows 8 laptop I cannot even get to the settings option of the Bluetooth.

Well that doesn't surprise me on W8. You need a big shovel to dig deep into W8 to figure things out.

My limited knowledge on Bluetooth has been exceeded at this point. 

That is as far as I know too. Thank you very much but in my case am beginning to suspect a virus, as this is happen on two different laptops. The first on my Win 7 and now on my new Win 8 laptop.

File are common as I have to transfer the files from the old one to the new one.

Once again thanks for your help and time. 

RSS

Search

Translate

Latest Activity

Paul Cloutier posted a discussion

nXtRender vs AutoCAD RT

My first try with nXt.Same models, same textures, same lights (ies 100W x 4).2 minutes render time.See More
Dec 25, 2019
Paul Cloutier replied to Paul Cloutier's discussion Material help !
"Hello Kevin Thanks. I will look at Yoooootube for more infos."
Dec 25, 2019
Kevin Lockwood replied to Paul Cloutier's discussion Material help !
"I used your mask (alpha) file as a mask in photoshop and saved out to png."
Dec 24, 2019
Paul Cloutier replied to Paul Cloutier's discussion Material help !
"Hello Kevin It's work with your .PNG file. Did you just SAVEAS a .JPG to a .PNG with a image editor ? Capture.PNG Render.png"
Dec 24, 2019
mike makki replied to Daniel Hargreaves's discussion Accustudio
"I can help daniel"
Dec 24, 2019
Kevin Lockwood replied to Paul Cloutier's discussion Material help !
"I'm not sure if you are applying the tree to the region as a decal or as part of a material. if a decal onto the region, I don't think AR will allow 2 decals. I guess you could stack them but I don't think one applies to the other…"
Dec 23, 2019
Paul Cloutier posted a discussion

Material help !

Hello...Need help for settings alpha for this tree bitmap.AutoCAD 2018.Thanks !See More
Dec 23, 2019
Daniel Hargreaves posted a discussion

Accustudio

I know this is hard to believe, but Accustudio is over 20 years old. It has been quiet for a couple of years now at the site. I'm looking to hand it off to the next generation. Is there anyone interested in working on the site and eventually taking over the ownership of it?See More
Dec 3, 2019

© 2020   Header image courtesy Peter Milner   Powered by

Badges  |  Report an Issue  |  Terms of Service