AccuRender nXt

advanced rendering for AutoCAD

Hi Guys

i hope someone can point me in the right direction here, i am doing an internal image as a night scene. so i have a few lights in the model but for some reason when i set it to render half of the lights dont show up as being turn on, so it ruins the whole scene. Any ideas?

thanks guys.

Rick

Views: 170

Reply to This

Replies to This Discussion

depending on the number of lights you have in the scene, NXT renders (be default) eight lights every pass. So if you have more than eight lights you do not expect them all to render immediately in the first pass.

thanks mate, so after a few passes they should show up right? the image looks a bit funny, i have had to turn the sun on a get some natural light in there and combine it with some lighting fixtures. do you have any other tips for internal lighting? thanks for replying mate.

Model the wall, put in your lights, then render and make adjustments as necessary. When all is done and ok. Bring in the furnitures. Meanwhile check Peter Milner Sample Office.

cool, thanks man.

Yes all other lights will come up later and also, with lights use real world units when specifying, the luminance  of lighting fixtures.

what do you mean about real world unit?

The same wattage that would be produce had you bought the bulb from the store.

ohh, yeh ive done that on all the lights. thanks again man

Send the drawing if you can't figure it out.  Use the upload link under Support.

RSS

Search

Translate

Latest Activity

Paul Cloutier posted a discussion

nXtRender vs AutoCAD RT

My first try with nXt.Same models, same textures, same lights (ies 100W x 4).2 minutes render time.See More
Dec 25, 2019
Paul Cloutier replied to Paul Cloutier's discussion Material help !
"Hello Kevin Thanks. I will look at Yoooootube for more infos."
Dec 25, 2019
Kevin Lockwood replied to Paul Cloutier's discussion Material help !
"I used your mask (alpha) file as a mask in photoshop and saved out to png."
Dec 24, 2019
Paul Cloutier replied to Paul Cloutier's discussion Material help !
"Hello Kevin It's work with your .PNG file. Did you just SAVEAS a .JPG to a .PNG with a image editor ? Capture.PNG Render.png"
Dec 24, 2019
mike makki replied to Daniel Hargreaves's discussion Accustudio
"I can help daniel"
Dec 24, 2019
Kevin Lockwood replied to Paul Cloutier's discussion Material help !
"I'm not sure if you are applying the tree to the region as a decal or as part of a material. if a decal onto the region, I don't think AR will allow 2 decals. I guess you could stack them but I don't think one applies to the other…"
Dec 23, 2019
Paul Cloutier posted a discussion

Material help !

Hello...Need help for settings alpha for this tree bitmap.AutoCAD 2018.Thanks !See More
Dec 23, 2019
Daniel Hargreaves posted a discussion

Accustudio

I know this is hard to believe, but Accustudio is over 20 years old. It has been quiet for a couple of years now at the site. I'm looking to hand it off to the next generation. Is there anyone interested in working on the site and eventually taking over the ownership of it?See More
Dec 3, 2019

© 2020   Header image courtesy Peter Milner   Powered by

Badges  |  Report an Issue  |  Terms of Service