AccuRender nXt

advanced rendering for AutoCAD

Gentlemen,

I used to work with arnxt64_0349_OA30 for some time.
Yesterday I have downloaded arnxt64_0358_RI18.

Any special procedure to make it work (with AutoCAD 2013) or just run the file?

And will I have to do anything with my license?

Views: 236

Reply to This

Replies to This Discussion

You simply need to run the executable file that you downloaded and then start AutoCAD. It will overwrite the older version that you have installed..

You will need to renew your license to run the new version. Otherwise it will run in Demo mode, with the resolution limited to 200,000 pixels.

You can purchase the renewal here:

http://nxtrender.com/purchase/renewals/

Which means, the arnxt64_0349_OA30 built is the one I can re-install any time I like?

Or, is this the last legal one for me?

RSS

Search

Translate

Latest Activity

Brittany Watson replied to Brittany Watson's discussion Groundcover Issues
"Hi Ben, You were absolutely right! I took over a computer that was previously used for rendering by someone else. The Accurender Plant Editor was on the desktop and used as the primary plant editor, so I assumed it was the only one. Thank you so…"
May 18
Ben Mixson replied to Brittany Watson's discussion Groundcover Issues
"Hi Brittany, I have two different plant editors. The Accurender plant editor that installed with Accurender Studio and the NXT plant editor that installed with NXT for Autocad. Only the NXT for Autocad version lets you open, modify, and save…"
May 14
Brittany Watson posted a discussion

Groundcover Issues

Hello,I am hoping to get some clarity on how to modify and add groundcover. I have searched everywhere on the forum and online to find how to save a plant as .ArGroundcover, but I cannot find anything. I am using AccuRender Plant Editor and once I finish editing the plant that I want to use as a groundcover, I click "save plant as", but all it allows me to save as is .ArTree. I have a deadline to get this render finished, but I cannot for the life of me figure this out. See More
May 14
Roy Hirshkowitz replied to Roy Hirshkowitz's discussion AccuRender Studio
"Thanks, I'll check on the first two.  The third is normal behavior-- data conversion stops when the arstudio data is detected.  There is a command to remove the arstudio data which would allow you to start from scratch-- probably not…"
Apr 19
Peter Milner replied to Roy Hirshkowitz's discussion AccuRender Studio
"Two things don't seem to translate from nXt: Procedural bump and orientation of texture in a material.   Also, if a decal is changed using nXt, Studio continues to display the original decal. Editing the decal in the Studio material pallet…"
Apr 19
Peter Milner replied to Roy Hirshkowitz's discussion AccuRender Studio
"That sorted it - using the Studio camera and then selecting "Get AutoCAD view"."
Apr 19
Roy Hirshkowitz replied to Roy Hirshkowitz's discussion AccuRender Studio
"Interesting.  ArStudio has its own WalkAbout-like feture, it's the little camera button.  If you do it while the preview is running you should see the view changes automatically in the rendering."
Apr 19
Peter Milner replied to Roy Hirshkowitz's discussion AccuRender Studio
"I'm having trouble getting the desired view in Studio. I've tried setting the view in nXt walkabout and then using that to set the AutoCAD view. However, when I render from Studio, it gives me something different (see images below)."
Apr 19

© 2021   Header image courtesy Peter Milner   Powered by

Badges  |  Report an Issue  |  Terms of Service