Crashing using lots of RPC

[Alejandro Testa]

Hi guys, I am doing a landscpae project, using  a lot of RPC plants images,  everything works OK  until this morning when I Insert some new plants and copy others, from this moment every time I try to render an image the systems hangs up and Autocad and Nxt crashed, I already restar my system,  removed all the temporary files,   I audited the drawing and everything seems to be OK,  the problem always happen when I tried to render an image.  Any thoughts?

Could this be a bad RPC image?  Is there a limit using RPC images? I am running Nxt 64 Bits. 32 gb Ram I7 processor. Thanks in advance

[Roy Hirshkowitz]

Send the drawing if you can't figure it out-- use the upload link.  If you want to isolate the problem yourself-- start by either deleting the RPCs, or placing them on layers which can be turned off.

[Alejandro Testa]

I already do that,  without RPC everything work´s, with some RPC works, with all the RPC it crashed.

 I

[akinlolu olugboji]

If some works then a particular RPC or bunch of RPCs are the problem. You might need to do them in groups when you get to a group that crash then one by one in the group till you nail down the particular RPC or RPCs.

Only time I experience a freeze or crash is when I purge a drawing with RPC after I must have launch NXT. 

Alejandro Testa said:

I already do that,  without RPC everything work´s, with some RPC works, with all the RPC it crashed.

 I

[Alejandro Testa]

Thanks Akin,   yesterday I deleted some RPC, and everythig seems to be working.