AccuRender nXt

advanced rendering for AutoCAD

I have updated the all profiles to include your website or blog address.  Go to the setting pick to the right under your profile name to update your profile.

Views: 73

Reply to This

Replies to This Discussion

Can you add multiple addresses? Maybe using html code?
Give that a try, I updated it to multiple addresses.
That works .. Thanks
Also we would like the ability to have some of the interesting features of the old forum back like.

1. Using advance editing like bullet in replying to topics and no just limiting it to when you are starting a new one.
2. Clicking on the last post of a discussion instead of having to go to the beginning again especially for long page discussion.
3. A way to directly link the old forum to this new one as some folks still post there.

Where is the other sub-forum for Revit, Sketch-Up Rhino etc

RSS

Search

Translate

Latest Activity

Roy Hirshkowitz replied to Roy Hirshkowitz's discussion AccuRender Studio
"Thanks, I'll check on the first two.  The third is normal behavior-- data conversion stops when the arstudio data is detected.  There is a command to remove the arstudio data which would allow you to start from scratch-- probably not…"
Apr 19
Peter Milner replied to Roy Hirshkowitz's discussion AccuRender Studio
"Two things don't seem to translate from nXt: Procedural bump and orientation of texture in a material.   Also, if a decal is changed using nXt, Studio continues to display the original decal. Editing the decal in the Studio material pallet…"
Apr 19
Peter Milner replied to Roy Hirshkowitz's discussion AccuRender Studio
"That sorted it - using the Studio camera and then selecting "Get AutoCAD view"."
Apr 19
Roy Hirshkowitz replied to Roy Hirshkowitz's discussion AccuRender Studio
"Interesting.  ArStudio has its own WalkAbout-like feture, it's the little camera button.  If you do it while the preview is running you should see the view changes automatically in the rendering."
Apr 19
Peter Milner replied to Roy Hirshkowitz's discussion AccuRender Studio
"I'm having trouble getting the desired view in Studio. I've tried setting the view in nXt walkabout and then using that to set the AutoCAD view. However, when I render from Studio, it gives me something different (see images below)."
Apr 19
Roy Hirshkowitz replied to Peter Milner's discussion Multiple cores
"There should be an Update Manager in the Start menu.  Grab and install 0267.  If this doesn't work I'll send a link."
Apr 16
Peter Milner replied to Peter Milner's discussion Multiple cores
"Okay. Just tried to install and run ArStudio, but I get this message inside AutoCAD:"
Apr 16
Roy Hirshkowitz replied to Peter Milner's discussion Multiple cores
"Sort of-- nXt has a hard-coded max of 32 but you get diminishing returns before than point.  If you go beyond 32 they can sometimes be used, depending on the load.  I guess I would still think of 32 as a practical limit. ArStudio should…"
Apr 12

© 2021   Header image courtesy Peter Milner   Powered by

Badges  |  Report an Issue  |  Terms of Service