Fehlermeldung

[Alfons Akamp]

Kann mir mal einer erklären, was diese Fehlermeldung in Acad 2011 bedeutet.

Siehe Bild

 

Alfons Akamp

[Roy Hirshkowitz]

Is the error consistent?  Does it happen every time you open this drawing?

[Alfons Akamp]

Yes, I have this error every time, but only with this drawing. I work with Build 280th Can it be that the drawing is too big? Size 180 MB!

Alfonso Akamp

[Roy Hirshkowitz]

I don't think so.  Not if it crashes when you type nXt.  32 or 64 bit?

[Alfons Akamp]

Open this file is only for Win 64 bit. Yes, this happens when I type AR5, but why?

Alfons

[Roy Hirshkowitz]

No idea.  Simplify the drawing as much as possible, then upload it.  Make sure the simplified one still crashes.  I'll take a look.

[Alfons Akamp]

I have tested this file now times on computers of colleagues with Acad 2010 and lo and behold, it comes at the same drawing, no error message.
Could it be the Acad 2011 has problems with ARX applications? Can someone from the forum to test both the Acad Acad 2010 and 2011, Win 7 has 64?
The 180 MB file for legal reasons I can not upload here unfortunately.

Alfons Akamp

[Roy Hirshkowitz]

It's tested and verified constantly on all of these platforms.  There are currently no known problems specific to Acad 2011.

[Alfons Akamp]

I found the error that is responsible for these messages. In my computer memory chips are defective from the memory and therefore could not properly save Acad.
Computer is currently in repair at my local dealer.



Alfons Akamp