Adding image on a curved wall?

[Éric Bérubé]

Hello all,

I'm trying to add two differents image on both side of a wall or a curved panel. With a box it work perfectly, I tried all parameter, doesn't work. Somebody help me?

I attached my files.

 

Merci

 

Éric

[akinlolu olugboji]

This I believe is what you want.

[Éric Bérubé]

Thanks for your explanation, I know how to attach an image on a curved wall but it always the same image on both side.

Did you create a rendering of both side? Actualy the image is the same on the dwg you sent.

 

Merci

Éric

 

[Roy Hirshkowitz]

This is possibly a bug-- the projection controls should take care of it (I think.)  Upload an example if you can-- zip up the decal as well.  Either use the upload link, or attach the file to a reply.

[Éric Bérubé]

There is a major bug for me, I am an Exhibit Designer and many booth I design have a double sided images panels.

I appreceate you help

 

Merci beaucoup

 

A attached the zip file

 

Éric 

[Peter Milner]

Did you change the projection from "Forwards and Backwards" to "Forwards Only"?

Also make sure it's single sided.

[Éric Bérubé]

Yes I tried everything. And I still working on it for the solution!

 

Thanks

 

Éric

[Roy Hirshkowitz]

If it's a bug with cylindrically projected decals, then you'll need to find a workaround until I get it fixed, which may be a while.  You can always use two surfaces separated by a small distance.  1 or 2 mm should do it.

[akinlolu olugboji]

Choose cylinder and not planar. Using object snaps, select the center.  The for the radius the endpoint of the curve not the mid point (note the inside one for the first decal and the outer end point for the other decal.) For width (moving anti-clock wise) select the end points and the height the lowest point and highest point.

[Sampdoria]

Nice explanation!

[akinlolu olugboji]

have two curves side by side and map them seperately.

[akinlolu olugboji]

Try this.

[Éric Bérubé]

 I'm working with too many block with curve and it will take too much time for to redraw a double piece on each.

 

I hope somebody at McNeel will work on this problem.

Thank you for the effort,

 

Éric from Montréal, Canada